Medical and dental implants demand surfaces that are clean, consistent and biocompatible.
That's why wet blasting, and specifically the Vapormatt Puma+, is so well suited to implant finishing.
Wet blasting is ideal for implants because it:
• Cleans and finishes in one controlled process, removing burrs, contaminants and machining marks without damaging critical geometries
• Generates less heat than dry blasting, protecting material properties in titanium for example
• Enables precise control of surface roughness to support osseointegration and sterilisation performance
• Suppresses dust, creating a safer, cleaner production environment
It's also highly effective for additive manufactured implants, where complex geometries and lattice structures demand uniform coverage and controlled surface refinement without compromising structural integrity.
The Vapormatt Puma+ brings this technology into a fully automated, repeatable platform:
• Programmable wet blast recipes via the HMI for validated, consistent processing
• Up to four Mk3 blast guns with a driven turntable for uniform coverage across complex implant shapes
• Integrated rinse, blow-off and S-Tank filtration with recirculated water to support controlled, efficient operation
• Stainless steel construction and built-in safety systems designed for regulated manufacturing environments
For manufacturers producing conventional or additive manufactured implants, surface finishing should strengthen your compliance story, not complicate it.
